Algae Discoloration of Roofs

For many years, roof discoloration caused by algae has been observed throughout the United States and Canada. The
discoloration usually has a brown to black appearance, and may be mistaken for fungus growth, soot, dirt, moss, or tree
droppings.
Gloeocapsa magma is probably the most prevalent of several algae species that contribute to discoloration. All species are
transported through the air, and tend to collect and grow upon roofing structures. Natural pigments produced by these algae
may cause a white or light colored roof to gradually turn dark brown or black. Discoloration may appear as uniform
discolorations or streaks. The algae discolorations should not be confused with moss or tree droppings, which typically
produce only localized discolorations.
This type of roof discoloration has been most widespread in the Gulf States and along the Northwest and Eastern Seaboards.
It is not, however, confined exclusively to these regions. Algae growth occurs to varying degrees in all regions of the country,
especially those subjected to warm, humid conditions. It should be noted that almost all types of roofing systems are
susceptible to algae discoloration. It is, of course, most readily visible upon light colored roofs, while it is not so visible upon
darker shades of roofing.
Algae discolorations are difficult to remove from roofing surfaces, but may be lightened by applying a solution of liquid
household chlorine bleach (sodium hypochlorite) and water. Directions for mixing solutions of these ingredients may vary
among shingle manufacturers and depend on the amount of discoloration. A typical solution should be one part chlorine
bleach and one part water. Other cleaning chemicals or methods should not be used without approval of the shingle
manufacturer.
First, gently disperse this solution on the roofing surface. Use normal precautions for handling bleach including eye protection
and rubber gloves. Be sure to apply it carefully to avoid damage to other parts of the building and the surrounding landscape.
Avoid scrubbing the surface, as this friction may loosen and remove granules. If possible, always work from a ladder and/or
walkboards to avoid direct contact with the roof surface. Observe all possible safety precautions when working on or near the
roof. The solution should be left on the roof for at least 15 minutes but for no more than 20 minutes. Finally, rinse the solution
from the roof by gently spraying the surface with water. Be warned that this solution application and rinse process will make
the roof surface slippery and potentially hazardous to walk on during treatment.
The effectiveness of a cleaning technique is only temporary, and discoloration will likely reoccur. However, several types of
algae resistant roofing products have been developed and are now commercially available. These asphalt roofing products
are specifically designed to inhibit algae growth for extended periods of time.
Caution!
High pressure washing systems are likely to damage asphalt roofing and should not be used on asphalt roofing for removing
algae or for any other purpose.